NX3 3D Flight Controller Gyroscope Balance For RC Plane Fixed-wing Aircraft

  • Brands Gartt
  • Product Code: NX3-01
  • Availability: In Stock
  • US$11.00


 

Product Information
 

Item Name:

NX3 3D Flight Controller Gyroscope Balance For RC Plane Fixed-wing Aircraft 


Description:

Voltage Range: 5-6V DC.

Dimensions: 40mm x 25mm.

Weight: 6.5g.


Feature:

1.Four Model Types supported: single aileron, dual ailerons , flapperons, delta and vtail.

2.Three Flight Modes supported:

a. Rate Mode ,Rate Mode for offset correction.

b. Hold Mode ,HOLD mode for attitude hold

c. Gyro Off Mode,transsmiter control the plane directly.

3.Two kinds of Gain Control Method supported:Master Gain from the radio, Independent Axis Gain from the Variable resistor on the Controller board.

4.Using superior algorithm, Bring a more comfortable and more sensitive sense of control .


VERY IMPORTANT :

The Controller has to re-learn center position after installation,or replacing a new radio system, or making a trimming(or Sub-Trim)change within the transmitter, otherwise the servos may move to one side automatically when switching to hold mode.To do this,just quickly flip the flight mode switch twice between rate mode and hold mode within 1 second!


Status LED Description:

LED OFF: NX3 in Gyro Off Mode.

LED ON: NX3 in Rate Mode.

LED flash: NX3 in Hold Mode.


WARNING :

PLEASE READ THE FOLLOWING STEPS VERY CAREFULLY BEFORE YOU START TO INSTALL A NEW PLANE!


Step 1:Mounting

The board need to be firmly mounted near the center of the gravity of the plane by using the double-tape provide.Please make sure the longer side of the board is along with the heading direction.After mounting ,please check again if the board is attached firmly in the plane.


Step 2:Model Type Selection

The DIP switches set the WING mode,Please match the type of your aircraft with Normal Airplane(single aileorn),Normal Airplane(dual aileron for flapperon), Delta-wing (Flywing-wing)and V-tail according the pictures 1 to 4. if you change any DIP switch settings, power cycle the device to enable the new setting to take effect.


Step 3:Wiring

Please connect the control board and the radio receiver using wires provide according the pictures 1 to 4.Pay attention to the color  of  wires to avoid anti-plug.


Includes:

1 Set NX3  Flight Control Board

   
 

Related Products